This is a 4 bolt magneto bracket for a Associated or United engine. The gear has just a small amount of rust pitting on one area that shouldn’t hurt anything. There is a little bit of wear in the gear and mounting shaft area but it should work fine for years. There is a couple small holes in the mag mounting area, that is an original casting flaw and not a weld. The mag mounting holes are 2-3/4″ x 2-3/4″ apart on center. The mounting holes to the engine are 1-3/4 apart on center. The push rod slot is 3/4. It is part number DVE. No cracks, breaks, or welds. Most items will go out faster though. I have many good parts and pieces I will be listing in the next few months. I try to do a very good job of listing everything I sell in a very accurate manner to explain all the good and bad points with the pictures and in the description. So if someone doesn’t pay I will ban them from my listings and also tell all my friends who also sell engine parts on here who to watch out for. If you haven’t caught on this is supposed to be mildly funny but yet serious at the same time. If you decide you don’t want it or find another one cheaper you I won’t take it back. For example if my measurements are wrong I would take it back. So here it is. Check out my other items. Be sure to add me to your favorites list. The item “ASSOCIATED UNITED MAGNETO BRACKET 4 Bolt Angle Drive Hit and Miss Old Gas Engine” is in sale since Sunday, January 01, 2017. This item is in the category “Business & Industrial\Light Equipment & Tools\Stationary Engines\Parts”. The seller is “hitmissengine” and is located in Holgate, Ohio. This item can be shipped worldwide.