I was told that this is for a steam engine. Sizing and shaft size is pictured below. Top part of this is a casting. I could not find any makers marks or number on this item. Condition is good, but not perfect.
This one starts easy and runs great. This could use a new spark plug wire & carb gasket. This would be a great engine to add to your collection, or start a collection! It’s a solid engine that could be improved with a little love.
Red section of belt indicates it is a 75 foot belt. Used Endless Flat Belt. But the Looped Length laid out is approx 37 feet (1/2 of 75 feet). Photos show it laid out to show condition.
I was told that this is for a steam engine. I cannot say that this is true because I do not know. Sizing and shaft size is pictured below. Top part of this is a casting. I could not find any makers marks or number on this item. Condition is good, but not perfect. Bare metal has light rust.
Vintage Industrial Hit-Miss Steam Gas Engine Flat Belt Pulley 15-1/4″ diameter 4-5/8″ wide. Used Flat Belt Pulley. Very heavy duty casting. Is 15-1/4 diameter at the edge. Face is 4-5/8 wide. Center hole is 1-3/16 diameter. Center hub width is approx 3-1/2 wide. Hub is offset to the one side. Has 1 drilled hole in the center hub, not threaded, and drilled at a slight inward angle. There is a heating discoloration across the flat surface. I assume this was done to help expand the casting when these pulleys were taken off years ago. I have another same pulley listed separately. That one has a shallow key-way & no drilled hole in the hub though.