Here is a Webster K magneto. This mag has the desirable all brass body. It makes an excellent spark. The bearings have only very minimal wear. The back bearing plate is a pot metal replacement but that will not hurt a thing. Reproduction brass bearing plates are available if you ever wanted to change it out. Please take a look at the pictures and decide if you need it. For questions 419 789 1159. The mounting pattern is about 2″ x 2″. Tight bearings, the armature spins freely with the springs off. Strong magnetic pull can be felt when turning the armature. This is a low tension magneto meant to work with an igniter. It will not produce a spark that will jump an air gap no matter who tells you it will or how close you hold the wire to ground.. It makes a spark that can be seen when the igniter points open. Most items will go out faster though. I have many good parts and pieces I will be listing in the next few months. I try to do a very good job of listing everything I sell in a very accurate manner to explain all the good and bad points with the pictures and in the description. So if someone doesn’t pay I will ban them from my listings and also tell all my friends who also sell engine parts on here who to watch out for. If you haven’t caught on this is supposed to be mildly funny but yet serious at the same time. If you decide you don’t want it or find another one cheaper you I won’t take it back. For example if my measurements are wrong I would take it back. So here it is. Rozevink Engines LLC 14316 St Rt 281 Holgate, Ohio 43527. Check out my other items. Be sure to add me to your favorites list.