Here is a Webster M magneto. It makes an excellent spark and has only a minimal amount of wear. It is slightly chipped by a bearing but that won’t hurt it at all. Please take a look at the pictures and decide if you need it. For questions 419 789 1159. The mounting pattern is about 2″ x 1-1/2″. All studs are tight in their holes. Minimal wear, the armature will turn freely with the springs off. Strong magnetic pull can be felt when turning the armature. This is a low tension magneto meant to work with an igniter. It will not produce a spark that will jump an air gap no matter who tells you it will or how close you hold the wire to ground.. It makes a spark that can be seen when the igniter points open. Most items will go out faster though. I have many good parts and pieces I will be listing in the next few months. I try to do a very good job of listing everything I sell in a very accurate manner to explain all the good and bad points with the pictures and in the description. So if someone doesn’t pay I will ban them from my listings and also tell all my friends who also sell engine parts on here who to watch out for. If you haven’t caught on this is supposed to be mildly funny but yet serious at the same time. If you decide you don’t want it or find another one cheaper you I won’t take it back. For example if my measurements are wrong I would take it back. So here it is. Rozevink Engines LLC 14316 St Rt 281 Holgate, Ohio 43527. Check out my other items. Be sure to add me to your favorites list.