I think this might be a clutch for an Olds hit and miss engine, but I don’t know that for sure. This is being offered “AS IS” as you see it in the pictures and from the description. It is stuck, but in my experience these old engine clutches are pretty easy to loosen up with a little heat. There are no cracks, breaks, or welds that I can see or know of. Check out the pictures and see if you need it. The pulley face is 10″ diameter, 6″ wide. Mounts with three bolt holes 6-1/2 apart on center each from the next closest one. The mounting holes are 5/8. NO Cracks, Breaks, or Welds! Most items will go out faster though. I have many good parts and pieces I will be listing in the next few months. I try to do a very good job of listing everything I sell in a very accurate manner to explain all the good and bad points with the pictures and in the description. So if someone doesn’t pay I will ban them from my listings and also tell all my friends who also sell engine parts on here who to watch out for. If you haven’t caught on this is supposed to be mildly funny but yet serious at the same time. If you decide you don’t want it or find another one cheaper you I won’t take it back. For example if my measurements are wrong I would take it back. So here it is. Check out my other items. Be sure to add me to your favorites list. The item “OLDS 8 CLUTCH PULLEY Bolt On Hit and Miss Old Gas Engine” is in sale since Sunday, December 06, 2015. This item is in the category “Business & Industrial\Light Equipment & Tools\Stationary Engines\Parts”. The seller is “hitmissengine” and is located in Holgate, Ohio. This item can be shipped to United States.
- Country/Region of Manufacture: United States