Here is an old Brunner Air Compressor made in Utica NY. A little bit of the back end appears to have been broken off. Many people make model engines out of these little critters. Take a look at the pictures and decide if you need it! Back end broken off, I do not have anything other than what is pictured. 1-1/2″ Bore, 1-1/2″ Stroke. The mounting base is about 6-5/8 long. The block itself it about 9-5/8 long. 5 Flywheel or pulley. I try to list items very accurately but my opinions on condition may vary from yours. Most items will go out faster though. I have many good parts and pieces I will be listing in the next few months. I try to do a very good job of listing everything I sell in a very accurate manner to explain all the good and bad points with the pictures and in the description. So if someone doesn’t pay I will ban them from my listings and also tell all my friends who also sell engine parts on here who to watch out for. If you haven’t caught on this is supposed to be mildly funny but yet serious at the same time. If you decide you don’t want it or find another one cheaper you I won’t take it back. For example if my measurements are wrong I would take it back. So here it is. Check out my other items. Be sure to add me to your favorites list. The item “BRUNNER AIR COMPRESSOR to be used to make MODEL HIT & MISS ENGINE” is in sale since Monday, February 06, 2017. This item is in the category “Business & Industrial\Light Equipment & Tools\Stationary Engines\Parts”. The seller is “hitmissengine” and is located in Holgate, Ohio. This item can be shipped worldwide.